1 . The most common used input signal(s) in control system is/are
[AMIE Sec B Circuit theory and control Summer 2007]
a) step function
b) ramp or velocity function
c) accelerating function
d) all of above
[AMIE Sec B Circuit theory and control Summer 2007]
a) step function
b) ramp or velocity function
c) accelerating function
d) all of above
2 . What is characteristics of good control system?
[UPSC IES EE-II 2009]
a) Sensitive to parameter variation
b) insensitive to input commands
c) neither Sensitive to parameter variation nor Sensitive input commands
d) insensitive to parameter but Sensitive to to input commands
3 . The system described by the equation y=a+bx,a>0,b>0 is
[AMIE Sec B control system Winter 2005;Summer 2007]
a) dynamic
b) linear
c) non-linear
d) time varying
4 . Linear system obeys
[AMIE Sec B Circuit theory and control Summer 2006]
a) principle of maximum power transfer
b) reciprocity principle
c) principle of superposition
d) all of these
5 . A system can be completely described by transfer functionif it is
[UPSC IES EE-I 2007]
a) non-linear and continous
b) linear and time varying
c) non-linear and time invariant
d) linear and time invariant
6 . If a linear time invariant system is excited by a true random signal like a white noise , the output of linear systeimwill have which of the following properties ?
[UPSC IES ETE-I 2007]
a) output will be white noise
b) output will be periodic
c) output will not be random
d) output will be correlated or coloured noise
7 . A function of one or more variables which conveys information on the nature of physical phenomenon is called
[UPSC IES ETE-I 2007]
a) noise
b) interference
c) system
d) signal
8 . If the initial conditions for a system are inherently zero,what does it physical mean ?
[UPSC IES ETE-II 2007]
a) the system is at rest but stores energy
b) the system is working but does not stores energy
c) the system is at rest or no energy is stored in any of its parts
d) the system is working with zero reference input
9 . In a control system, the use of negative feedback
[UPSC IES EE-II 1993]
a) eliminates the chances of instability
b) increase reliability
c) reduces effects of disturbance and noise signals in forward path
d)increases the influence of variations of component parameters on system performance
10 . Which one of following effect in system is NOT caused by negative feedback ?
[UPSC IES EE-I 2003]
a) Reduction in gain
b) Increase in bandwidth
c) Increase in distortion
d) reduction in output impedance
0 comments:
Post a Comment